Drag depends on
the density
of the air, the square of the velocity, the
air's viscosity and compressibility, the
size and shape of
the body, and the body's inclination to
the flow. In general, the dependence on body shape, inclination, air
viscosity, and compressibility is very complex.
One way to deal with complex dependencies is to characterize the
dependence by a single variable. For drag, this variable is called
the drag coefficient, designated
"Cd." This allows us to collect all the effects, simple and
complex, into a single equation.
The drag equation states that drag D is equal to the
drag coefficient Cd times the density r times half of the
velocity V squared times the reference area A.
D = Cd * A * .5 * r * V^2
For given air
conditions, shape, and inclination of the object, we must determine a
value for Cd to determine drag. Determining the value of the
drag coefficient is more difficult than
determining the
lift coefficient because of the multiple
sources of drag. The drag coefficient given above includes form
drag, skin friction drag, and wave drag components.
Drag coefficients are almost always
determined experimentally using a wind
tunnel.
Notice that the area (A) given in the drag equation is given as a
reference area.
The drag depends directly on the size
of the body. Since we are dealing with aerodynamic
forces, the dependence can be characterized by some area. But
which area do we choose? If we think of drag as being caused by
friction between the air and the body, a logical choice would be the
total surface area of the body. If we think of drag as being a
resistance to the flow, a more logical choice would be the frontal
area of the body that is perpendicular to the flow direction. And
finally, if we want to compare with the lift coefficient, we should
use the same wing area used to derive the lift coefficient. Since the
drag coefficient is usually determined experimentally by measuring
drag and the area and then performing the division to produce the
coefficient, we are free to use any area that can be easily
measured. If we choose the wing area, rather than the crosssectional
area, the computed coefficient will have a different value. But the
drag is the same, and the coefficients are related by the ratio of
the areas. In practice, drag coefficients are reported based on a
wide variety of object areas. In the report, the test engineer must
specify the area used; when using the data, the reader may have to
convert the drag coefficient using the ratio of the areas.
In the equation given above, the density is designated by
the Greek letter "rho." We do not use "d" for density
since "d" is often used
to specify distance. The combination of
terms "density times the square of the velocity divided by two" is
called the
dynamic pressure
and appears in Bernoulli's
pressure equation.
Guided Tours

Rocket Aerodynamics:

Viscous Aerodynamics:
Activities:
Related Sites:
Rocket Index
Rocket Home
Exploration Systems Mission Directorate Home
